Nidec-Embraco NEK2168GK1 3/4HP Compressor R404A 115V 1-Phase
Specifications
- Type: Compressor
- Power: 3/4 HP
- Voltage: 115V
- Application: Refrigeration
- Weight: 27.98lbs
- Temperature: -20°F-100°F
- Phase: 1-Phase
Loyalty ProgramRefrigeration equipment depends on controlled refrigerant circulation to maintain the cooling process. The Nidec-Embraco NEK2168GK1 compressor performs the compression stage within this cycle, preparing refrigerant vapor for continued movement through the refrigeration circuit. It is intended for refrigeration applications where the specified compressor configuration is required.
REFRIGERATION CYCLE AND COMPRESSION:
Compression is a key stage in the refrigeration cycle, as it raises the pressure of refrigerant vapor before the refrigerant enters the condenser. After releasing heat, the refrigerant continues through the remaining stages of the circuit before returning to the compressor. This pressure-driven process supports continuous refrigerant circulation and the system's overall cooling operation.
ELECTRICAL AND POWER REQUIREMENTS:
The 115V, single-phase electrical configuration identifies the listed power supply requirement for this compressor. Its 3/4 HP rating indicates the stated motor power classification. These characteristics are important when evaluating a replacement for existing refrigeration equipment because electrical supply and compressor power requirements must correspond with the equipment specifications.
REPLACEMENT GUIDELINES:
Replacement may be necessary when a compressor develops a fault that prevents normal operation or cannot maintain the required refrigeration performance. Before replacing the existing unit, establish whether the problem originates in the compressor or another part of the refrigeration system. Compare the NEK2168GK1 part number with the equipment manufacturer's parts documentation and confirm the approved replacement requirements before ordering.
COMMON FAILURE SYMPTOMS:
EQUIPMENT COMPATIBILITY:
The Nidec-Embraco NEK2168GK1 is identified for refrigeration applications using the listed R404A refrigerant and 115V, single-phase electrical configuration. Specific compatible equipment models have not been established here. Before ordering, compare the existing compressor part number, equipment model, refrigerant requirement, electrical supply, and applicable compressor specifications with the manufacturer's documentation.
TECHNICAL SPECIFICATIONS:
Part Identification:
Brand: Nidec-Embraco
Part Number: NEK2168GK1
Product Type: Compressor
Application: Refrigeration
Mechanical Specifications:
Power: 3/4HP
Electrical Specifications:
Voltage: 115V
Phase: 1-Phase
Refrigerant Specifications:
Refrigerant: R404A
Step1: Turn off power to the refrigeration unit at the breaker and unplug it.
Step2: Recover refrigerant per regulations before opening the system.
Step3: Disconnect electrical leads and refrigerant lines from the old compressor.
Step4: Remove the old compressor and clean the mounting area.
Step5: Install the new compressor, reconnect lines with proper brazing, and tighten fittings.
Step6: Evacuate, recharge with R404A, restore power, and test for correct operation and leaks.