International Comfort Products 1186441 1 HP ECM Blower Motor
Specifications
- Type: ECM Blower Motor
- Horsepower: 1HP
- Voltage: 120V
- Frequency: 50/60 Hz
Loyalty ProgramECM blower motors provide electronically managed drive for HVAC blower assemblies. The International Comfort Products 1186441 is a 1 HP ECM blower motor that supplies mechanical movement to the connected blower, supporting its air-moving function within the associated HVAC system.
ECM Motor Control:
An ECM uses electronic circuitry to manage the motor's operating response during operation. This electronic control allows the motor to vary its operating behavior rather than relying on a conventional fixed operating arrangement, producing controlled rotational output for the connected blower.
Shaft Drive for Blower Operation:
The motor transfers mechanical movement through its shaft to the connected blower assembly. As the shaft rotates, the blower receives the motor's mechanical output and uses that movement to rotate the blower assembly within the HVAC system.
Replacement Guidelines:
Replacement may be appropriate when the motor develops a persistent electronic operating fault or when its mechanical output deteriorates enough to affect the connected blower assembly. Before ordering the International Comfort Products 1186441, compare the existing part number with the applicable equipment requirements and verified motor specifications.
Common Failure Symptoms:
Equipment Compatibility:
The International Comfort Products 1186441 ECM Blower Motor is associated with models N80ESN1102120A1, R80ESL1102120A1, and N80ESN. When selecting this motor, verify the existing 1186441 part number, ECM motor configuration, horsepower, and applicable equipment model requirements against the original equipment documentation.
Technical Specifications:
Part Identification:
Brand: International Comfort Products
Part Number: 1186441
Product Type: ECM Blower Motor
Mechanical:
Horsepower: 1 HP
Step 1: Turn off power to the HVAC system to ensure safety.
Step 2: Access the blower compartment by removing the panel or cover.
Step 3: Disconnect the old motor’s wiring and mounting hardware.
Step 4: Remove the existing blower motor carefully from the assembly.
Step 5: Install the new motor onto the blower housing.
Step 6: Reconnect wiring according to the manufacturer’s diagram.
Step 7: Restore power and test the blower for proper operation.