Mueller Industries A11042 Angle Valve 3/8" X 1/2"
Specifications
- Size: 1/2"
- Type: Angle Valve
- Material: Brass
- Pressure Regulator(PSI): 700 PSI
- Weight: 0.56 Lbs
Loyalty ProgramPRODUCT OVERVIEW:
An angle service isolation valve functions as a directional flow control device designed to regulate fluid movement or manage 90-degree line transitions within HVAC, commercial refrigeration, and plumbing networks. Mueller Industries A11042 OEM is a manual shut-off component engineered for line isolation, throttling, and direction change across compatible piping circuits. Installed at equipment manifolds or line transition points, it features a 90-degree angle body layout with 3/8" x 1/2" connection ports. Proper valve operation delivers positive manual shutoff during maintenance, reduces piping stress, and supports smooth fluid routing.
ANGLED FLOW REGULATION AND DIRECTIONAL CONTROL:
The valve operates using an internal stem and seating assembly that opens or seals the fluid passage across a 90-degree internal turn. Positioned at line turns, the right-angle body geometry redirects fluid flow while eliminating the need for an additional elbow fitting. Turning the top stem mechanism translates mechanical force to position internal closure components against the valve seat, allowing technicians to throttle flow volume or achieve tight system isolation.
LINE INTEGRATION AND FLUID ISOLATION:
The valve is equipped with 3/8" x 1/2" connection ports, allowing the heavy-duty body to integrate directly into matching 3/8" and 1/2" piping lines. When turned to the fully seated or closed position, the internal valve disc forms a bubble-tight seal against the valve seat to stop fluid pass-through entirely. This complete shutoff enables technicians to isolate specific lines or equipment sections for filter changes and component replacements without discharging the surrounding fluid circuit.
REPLACEMENT GUIDELINES:
Replace the angle valve when inspection reveals stem packing leakage, internal seat bypass when fully closed, stem binding, or severe joint corrosion. Because replacing inline solder or threaded angle valves involves handling pressurized fluids or refrigerants, line evacuation, and mechanical connection or torch brazing, work must be performed by a qualified HVAC or mechanical technician. The technician must safely recover system fluids, isolate line pressure, protect internal valve seals during soldering or fitting installation, evacuate the circuit if applicable, and conduct leak checks under operating pressure. Always verify technical documentation to confirm component fitment before installation.
COMMON FAILURE SYMPTOMS:
EQUIPMENT COMPATIBILITY:
Mueller Industries A11042 Angle Valve is intended for select commercial refrigeration, HVAC, and liquid piping applications requiring a 3/8" x 1/2" angle service valve. Confirm that your piping layout requires a 90-degree angle pattern and 3/8" x 1/2" line connection sizes. Cross-reference original equipment data sheets and piping schematics to verify fitment prior to purchasing.
TECHNICAL SPECIFICATIONS:
Product Identification:
Brand: Mueller Industries
Part Number: A11042
Product Type: Angle Valve
Structural & Operational Specifications:
Connection Size: 3/8 Inch x 1/2 Inch
Valve Pattern Angle: 90-Degree Right-Angle Body Layout
Step 1: Turn off main water supply and relieve pressure.
Step 2: Remove existing valve and clean pipe threads.
Step 3: Apply thread seal tape and hand-tighten new angle valve, then wrench snug.
Step 4: Connect supply line to outlet, ensuring proper alignment and no cross-threading.
Step 5: Slowly turn water on and check for leaks; tighten if needed.