Facebook Pixel

Nordyne 667279R Condenser Fan Blade 20" Diameter 26° Pitch

Special Price $74.74 Regular Price $85.95
In stock
SKU
667279R
The Nordyne 667279R Condenser Fan Blade is the critical part of HVAC systems that are made to enhance airflow and consequently improve the efficiency of condensers is embodied. It is known for its good air circulation because it has a diameter of 20 inches and a pitch of 26 degrees. Commonly used in Nordyne air conditioners, it may also work with some other brands as well. Basically pulling outside air in and pushing warm air out from the coil are the prime functions of this blade allowing for better heat transfer hence cooling the refrigerant.
https://www.partshnc.com/media/catalog/product/6/6/667279r.jpg

Specifications

  • Type: Condenser Fan Blade
  • Number of Blades: 3
  • Diameter: 20"
  • Pitch: 26°
  • Bore Diameter: 1/2"
Manufacturer Name: Nordyne
Product Number: 667279R
OEM Part Number: 667279R
Product Description: Condenserfanblade 20"Dia 26Deg
Weight:5lbs/2267.96g

Choose the best HVAC equipment parts and supplies from PartsHnC!

  • Same Day Shipping

  • Best Quality And Best Price

  • Wide Range of Inventory

  • Best Customer Service

Have More Questions or Need Help to Place The Order?
Reach us at (866)773-0907 or [email protected]

Write Your Own Review
You're reviewing:Nordyne 667279R Condenser Fan Blade 20" Diameter 26° Pitch
Your Rating
Customer Questions
What maintenance is required for the Nordyne 667279R Condenser Fan Blade?

Regularly inspect the fan blade for dirt buildup, cracks, or bending that could affect balance and airflow. Clean the blades gently to prevent debris accumulation. Ensure mounting hardware is tight and secure. Always disconnect power before handling to avoid injury.

What are common issues with the Nordyne 667279R Condenser Fan Blade?

  • Blade imbalance causing vibration or noise.
  • Cracks or warping from environmental stress.
  • Reduced airflow due to dirt accumulation.
  • Improper installation leading to wobbling.
  • Motor strain caused by damaged or misaligned blades.

Installation Steps

Step 1: Disconnect power to the condenser unit and apply lockout/tagout for safety.

Step 2: Remove top grille and note original blade orientation and rotation direction.

Step 3: Loosen set screw and carefully remove old fan blade from motor shaft.

Step 4: Install new blade, aligning correct pitch and ensuring proper airflow direction.

Step 5: Set blade height on shaft to match original position for proper clearance.

Step 6: Tighten set screw securely and check blade is balanced and spins freely.

Step 7: Restore power and test operation, checking airflow, vibration, and motor load.